Installing The Bracket - Control 4 CHIME Quick Start Manual

INSTALLING THE BRACKET
Caution! Disconnect power to the doorbell transformer or power to the circuit at the circuit
breaker before starting.
1. Remove the doorbell and disconnect the two wires on the back.
2. Using the template included in the box, mark the holes for mounting the VDB and the cable
passthrough cutout.
Trim the template and mark the camera outline if you need to modify the building materals
(trim, rock, brick, etc.) to make the VDB fit.
Important! The VDB should never be mounted more than 6 ft (2 m) off the ground.
Important! Make sure existing doorbell wire lines up with the cable passthrough cutout.
3. Drill 3/32" (2.4 mm) pilot holes for the wood screws to mount the metal bracket. If using the
anchors, drill 3/16" (4.8 mm) pilot holes for the anchors.
Important! Use appropriate anchors if installing the VDB to stucco, brick, or other construction
material. Wood screws are included in the box.
4. Install the metal bracket for the VDB using the provided screws. Pull the doorbell cable
through the bracket before installation.