Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Control 4 C4-VDB-E
Summary of Contents for Control 4 C4-VDB-E
- Page 1 CHIME VIDEO DOORBELL (PoE) SETUP GUIDE...
-
Page 2: Table Of Contents
Contents ctrl4.co/vdb-e-ig To view the online version of this document, go to Contents PREREQUISITES CONTENTS IMPORTANT NOTES AND CAUTIONS INSTALLING THE VIDEO DOORBELL CONNECTING THE VDB TO YOUR NETWORK (POE MODEL) CONNECTING THE VDB TO YOUR CONTROL4 SYSTEM TROUBLESHOOTING RESETTING TO FACTORY DEFAULTS RESETTING NETWORK SETTINGS LED STATUS INFORMATION MORE INFORMATION REGULATORY AND SAFETY INFORMATION WARRANTY... -
Page 3: Prerequisites
PREREQUISITES Control4 system running OS 3.2 or higher For the PoE model (C4-VDB-E)—Cat5e/6 or better wiring to PoE injector or PoE switch (802.3af PoE, injector not included) If you want to use the external chime feature, a doorbell chime, doorbell transformer, and 18-22 gauge 2-conductor wire to the doorbell chime are required. -
Page 4: Connecting The Vdb To Your Control4 System
CONNECTING THE VDB TO YOUR CONTROL4 SYSTEM Continue to the next topic ( CONNECTING THE VDB TO YOUR CONTROL4 SYSTEM 1. In Composer Pro 3.2.0 or newer, connect to your controller. 2. Verify that the Communication agent is added to the project. If it is not already added, go to Agents >... - Page 5 5. In the Settings > Maintenance tab, enter a new password, confirm the password, and click SUBMIT . 6. Optional —To enable a doorbell chime, in the DEVICE tab, move the slider to Enable under EXTERNAL CHIME FUNCTION.
- Page 6 7. Under Call Settings , select a call group for the VDB to ring (default is All ). To test an intercom call to a call group, select the group under TEST CALL GROUP and click TEST CALL . 8. Select the Intercom proxy sub-driver of the VDB. Configure Intercom properties such as Custom Buttons to show up in an Intercom call.
-
Page 7: Troubleshooting
TROUBLESHOOTING RESETTING TO FACTORY DEFAULTS To reset the VDB back to factory default settings: 1. In the driver Actions tab, click on Factory Reset. 2. Choose Yes or No on the Keep Network Settings? dialogue, and click OK . 1. Press the button on the VDB 13 times within 5 seconds. A recording tells you to "Cycle power to reset to factory defaults."... - Page 8 snapav.com/legal and patent information, at...
-
Page 9: About Control4
About Control4 Control4, a leading provider of the operating system for the smart home, delivers intelligent control of consumer electronics products, appliances and networking systems through an easy-to-use and intuitive software interface. Founded in 2003, the company delivers affordable automation and control of lighting, music, video, HVAC, security, and energy management systems to the broad market through more than 1,600 custom integrators, retail outlets, and distributors in over 65 countries. - Page 10 Spread This product uses software developed by Spread Concepts LLC for use in the Spread toolkit. For more information about Spread see http://www.spread.org. Libertas Libertas Firmware copyright statement for Touch Screens 6/26/09 Copyright (c) 2006, One Laptop per Child and Marvell Corporation. All rights reserved. Redistribution—Redistribution and use in binary form, without modification, are permitted provided that the following conditions are met: * Redistributions must reproduce the above copyright notice and the following disclaimer in the documentation...