Maintenance - DeWalt DCV580 Manual

English
Fig. F
5. Inspect machine for damage by foreign objects. Contact
the nearest D WALT authorized service center for
e
replacement of damaged or missing parts.
6. Replace power head onto the tank and latch securely.
nOTE: The machine must be used in the upright position at
all times to prevent unwanted actuation of the Automatic
Vacuum Shutoff. If unwanted actuation should happen, turn
off the motor and wait until the motor stops turning. Turn
the motor on again and suction will be restored.
Filter
Filter care (Fig. G)
The wet/dry filter 5 included with this vacuum is a long life
filter. To be effective in minimizing dust recirculation the
filters MUST be installed correctly and in good condition.
nOTE: Never operate without a filter in place. A clean filter
is the most important factor in the operation and efficiency
of any vacuum. If the filter becomes clogged beyond
cleaning, damaged, or fails to operate properly, replace only
with genuine D WALT replacement filters.
e
To Clean or Change the Filter (Fig. F, G)
1. Turn the machine off and remove the battery pack.
2. Unlatch the tank latches
from the tank. Twist the filter
from the power head.
Fig. G
3. Clean the filter by shaking off excess dust, tapping into
a waste receptacle, then rinsing under running water.
Depending on the condition of the filter, a water wash is
not always required. Do not use a brush to clean filter.
4. Reinstall and secure the filter onto the power head by
twisting the filter to the left.
5. Replace power head onto the tank and secure latches.
8
5
4
4 and remove the power head
5 to the right to remove it
5
Blower (Fig. A)
The blower function can be used to remove debris from
behind small spaces, to dry a damp floor, to blow grass
clippings or leaves from an outside walk, patio, etc.
To Use as a Blower
1. Empty the tank following the instructions under the
Vacuum Cleaning section of this manual.
2. Twist the vacuum hose
3. Insert the hose into the side exhaust port
to secure.

MAINTENANCE


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
• Empty the vacuum often, especially when wet debris is
in the canister.
• MAINTAIN TOOL WITH CARE. Keep fan area clean for
best and safest performance.
• Do not attempt to repair the vacuum. To assure
product safety and reliability, repairs, maintenance,
and adjustments should be performed by authorized
D WALT service centers.
e
Hose and Accessory Storage (Fig. A)
When the vacuum is not in use, the hose can be wrapped
around the appliance, underneath the battery interface, and
secured with the hose clip
vacuum. The two accessories (crevice tool and wide nozzle)
can be stored on board the vacuum as well.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Charger Cleaning Instructions

WARNING: Shock hazard. Disconnect the charger
from the AC outlet before cleaning. Dirt and grease
may be removed from the exterior of the charger using
a cloth or soft non-metallic brush. Do not use water or
any cleaning solutions.
2 to remove.
6 and twist
7 also located at the back of the