Table of Contents
Advertisement
VER-1832 Rack Ears
Available rack mount kits for the VIS-1832 have 1, 2 or 3 panel mount TAC-4 connectors mounted respectively and allow connection between
tactical grade fiber to the ST connectors on the VIS units. The illustration below is in the T-1 configuration.
Fiber Connection Plates
Each fiber connection on LightViper components can be
configured with any of the plates in the diagram. The plates
accommodate different fiber connector types either singly.
Four different ST plates accommodate 1, 2, 3, or 4 ST
connections. A blank plate should always be installed in an
unused connection bay.
TAC-4 Installation Instructions
Due to the hermaphroditic nature of the TAC-4 connector, channels 1 & 4 and
2 & 3 are crossed by necessity. Therefore, pins 1 & 2 should always be
connected to connectors marked TX and pins 3 & 4 should always be
connected to pins marked RX. Pins 1 & 4 are always paired together and pins 2
& 3 will always be paired together.
20
Advertisement
Table of Contents
