Burton Safes Keyguard Combi User Instructions

KEYGUARD COMBI
LOCK MODEL: KEYGUARD COMBI
Facts about the Keyguard Combi
KEY SYMBOLS
0
0 = PRESS
Burton Safes Limited Unit 12 Brockholes Business Park, Rock Mill Road, Brockholes, Holmfirth HD9 7BN. t 01484 663388 f 01484 666338 enquiries@keyguardsecurity.co.uk www.keyguardsecurity.co.uk
0
0 = HOLD = DOUBLE BEEP = SINGLE BEEP
USER INSTRUCTIONS

GETTING STARTED:

Please note that all Keyguard safes are supplied with the
preset default code of [0][0][0][0].
To open your Keyguard Combi for the rst time you should
replicate the following steps:
• Rotate the four combination dials so
that the [0] digit on each dial is lined
up beneath the red arrow.
• Firmly hold the facia of your Keyguard
Combi and simultaneously slide the
silver catch down wards.
• With the silver catch still pushed
downward pull the facia away from the safe body.

SETTING YOUR OWN CODE:

• Place the facia of your Keyguard Combi face down on
a rm surface.
• Decide upon your new personal 4-digit code. (It is
very important that you remember this combination.)
• To set your code you rst need to rst ensure that the
four combination dials are rotated so that the [0] digit
on each dial is lined up beneath the red arrow.
• Slide the 'code change pin' on the back of the facia
downward and to the right.
• Turn over the facia so that you are looking at the front
of it. Now turn each of the four dials so that your
personal 4-digit code (Read from top to bottom) is
lined up beneath the red arrow.
• Turn over the facia so that you are looking at the back
of it. Return the 'code change pin' on the back of the
facia to its normal position by sliding it to the left and
then upward.
• Once you have input your code you should check that
it has been correctly set. It is vital that you rst check
this with the Keyguard Combi open.
DO NOT YET REPLACE THE FACIA!
= LED FLASHES TWICE = LED STAYS ON
9 0 1
9 0 1
9 0 1
9 0 1
Pg. 1
KG-Inst-010
= I-BUTTON = LONG BEEP
July 2013