Advertisement
IV. Getting started
IV.4 S2 device status briefing
S2 device has four status: working, standby, charging and hibernate.
Working: the device is in normal work ， including motor start, wireless
connection, and etc, in following situations：
1. Logo light/speed indicator is on: Low - white, High - blue.
2. The wireless indicator stays on when connected; it flashes when device is
working but not in wireless connection.
3. Battery indicator is white in normal power, it is red and flashing when in low
battery power.
4. In two-hand mode (default mode), press the power button and all indicators
will turn on. Indicator lights stay on in single-hand mode.
5. In parental mode, logo light is purple; return to previous settings after
quitting parental mode.
6. In self-cleaning process, logo light is green and breathing; return to normal
after self-cleaning ends or exits.
Standby: When device is activated (press power button to activate) but not
working nor wireless connected, it is in standby status if not charging. Logo
light and battery indicators are off, and the wireless indicator flashes.
Charging: When charging the device, logo light will be yellow while breathing.
It will go out after 30s and the battery indicator will not be on.
Hibernate: The device shall hibernate when not in use within 5 minutes or
does not enter other status above. When in hibernation, all indicators are off.
Pressing power button could wake up and activate the device.
Working and charging are mutual exclusive: when device is working, it could
not be charged; when charging, pressing any button would stop charge.
IV.5 S2 Manual reset
S2 is equipped with a manual reset switch, which could be triggered through
the magnet on the adapter charging interface. The reset function could reset
S2 system and restart the device when unable to start the machine or the
device is in abnormal status.
Put the magnet on the charging interface close to the reset switch (located
above the wireless indicator) and stays for 3s. After removal the magnet, the
wireless indicator turns up again, then S2 is reset successfully and restarted.
© 2018-2020 GENEINNO All Rights Reserved.
7
Advertisement
