Ten-Haaft Oyster Vision II Quick Start Manual page 4

Additional Information

This document describes the update process with a "Simple Update Card". There are four
versions of this card: Vision II, Vision III, SunMoverSamy V1 and SunMoverSamyV2.

On the cards is a special variant of the EEP file. This leaves the individual user settings of the
system obtained.
 It is possible that the SD-card causes a reset after insertion (depending on the
hardware version of the control unit). In this case the box initiates a reconnect and
continues normally.

The check of a card can take longer if the card is damaged electrically  Please be patient!

As long as the programming is not active, the card can be removed at any time.
 It is also possible to send the update data via e-mail (self-extracting archive file that
will be unpacked on a card).
In this case, the used SD-card should be formatted with FAT32. This ensures that only
reasonable cards can be used (older SD cards or MMCs may work, but they are out of
specification. The same is true for SDHC cards).
Torsten Adam, tenHaaft GmbH 1 Page 4