Card slot
The card will be analysed, followed by the request
Proceed update?
Torsten Adam, tenHaaft GmbH
Please connect the control unit with the
system (...booting...,then ...finished!).
Now remove the cover on the right side.
Put the SD‐card into the slot until
it snaps into place (the side with
the golden contacts left‐handed
facing down).
Tip: To remove the card, please
push the card a little bit to release
the locking mechanism.
No
Please press OK to start system verification
and programming.
In case of errors they will be shown on display
(e.g. wrong updates, system type mismatch ...)
1
Yes
Page 2