Serato RELOOP TERMINAL MIX 2 Quick Start Manual page 4

VERSION 1.1.1
DJ-FX
The DJ-FX in Serato DJ are powered by iZotope™. Click the FX tab
to open the FX panel. Select either 1, 2, 3, 4 or M to assign the selected effect
bank to a deck or Master Output. To activate an effect, click the ON button on your
FX UNIT in the software, or the FX1 ON button on your controller. You can adjust
effect parameters by using either software controls, or the FX1/FX2/FX3 and FXSEL
knobs/buttons on the controller.
There are two available modes in the DJ-FX. Single FX Mode allows you to select
one effect per FX bank, and has multiple parameters that can be adjusted. Multi
FX Mode allows you to select up to three effects per FX bank, and adjust only
one parameter, the FX Depth. The same effects available in Single FX mode are
available in Multi FX mode, as well some additional presets.
You can select between the two FX modes by clicking either the Single FX mode
button or Multi FX mode button
Reloop Terminal Mix 2 Contol
Reloop Terminal Mix 2 Control
TAP
SHIFT + FXSEL 1-3 Buttons
FXSEL 3 Button
FXSEL 2 Button
FXSEL 1 Button
FX3 Knob
FX2 Knob
FX1 Knob
BEATS
*NOTE:* Use SHIFT + RANGE to assign FX UNIT 1 to the Active Deck. Use SHIFT + KEYLOCK to assign FX UNIT 2 to the Active Deck.
Single FX Mode
Single FX Mode
Tap to the desired FX tempo. To return to AUTO
mode, press and hold
Select Effect
Adjust Parameter 4
Adjust Parameter 2
Effect On/Off
Adjust Parameter 5
Adjust Parameter 3
Adjust Parameter 1
Adjust Beats Multiplier
Multi FX Mode
Multi FX Mode
Tap to the desired FX tempo. To return to AUTO mode,
press and hold
Select Effect in Slots 1-3
Slot 3 Effect On/Off
Slot 2 Effect On/Off
Slot 1 Effect On/Off
Adjust Slot 3 FX Parameter
Adjust Slot 2 FX Parameter
Adjust Slot 1 FX Parameter
Adjust Beats Multiplier