Advertisement
Quick Links
Specifications
100UPR Receiver
Frequency Range
UHF 63-Channel Selectable (793.750 – 805.875MHz)
Type of Reception
Antenna Diversity
Oscillator
PLL Synthesized
RF Squelch Level
16dBµV
Frequency Response
50Hz – 15kHz
S/N Ratio
>70dB "A" Weighted
Audio Distortion
<1% @ 1kHz
Operating Temp.
0°C – 50°C (32°F – 122°F)
MIC Out (Balanced)
-58dBm @ 600 Ω
-10dBm (Max) @ 33 Ω
Monitor Out
MIC Out Connector
3.5mm Balanced Mini-Jack
Monitor Out Connector 3.5mm Stereo Mini-Jack
Power Requirement
1 – 9V Alkaline Battery
Battery Life
6 – 8 Hours w/Alkaline Battery
Dimensions
62W x 100H x 22D mm (2.44W x 3.94H x 0.87D inches)
Weight
Approx. 120g Including Battery (4.23oz)
10BT Transmitter
Frequency Range
UHF 63-Channel Selectable (793.750 – 805.875MHz)
Oscillator
PLL Synthesized
RF Power
10mW (30mW Max.)
Frequency Response
50Hz – 15kHz
Max. Deviation
±75kHz @ 1kHz Modulation, MIC Input –11dBm
S/N Ratio
>70dB "A" Weighted
Audio Distortion
<1% @ 1kHz
MIC Sensitivity
±40kHz @ -22dBm MIC Input (0dBm+0.775V)
Operating Temp.
0°C – 50°C (32°F – 122°F)
MIC Input Connector
3.5mm Mini Jack
Power Requirement
1 – 9V Alkaline Battery
Battery Life
6 – 8 Hours w/Alkaline Battery
Dimensions
62W x 100H x 22D mm (2.44W x 3.94H x 0.87D inches)
Weight
Approx. 120g Including Battery (4.23oz)
10HT Transmitter
Frequency Range
UHF 63-Channel Selectable (793.750 – 805.875MHz)
Oscillator
PLL Synthesized
RF Power
10mW (30mW Max.)
Frequency Response
50Hz – 12kHz
Max. Deviation
±75kHz @ 1kHz Modulation, MIC Input –11dBm
S/N Ratio
>70dB "A" Weighted
Audio Distortion
<1% @ 1kHz
MIC Element
ECM
MIC Sensitivity
±5kHz @ -46dBm (0dBm+0.775V)
Operating Temp.
0°C – 50°C (32°F – 122°F)
Power Requirement
2 – "AA" Alkaline Battery (2x1.5V)
Battery Life
8-10 Hours w/Alkaline Battery
Dimensions
230H x Ø 44D mm (9.05H x 1.73D inches)
Weight
Approx. 130g Including Batteries (4.58oz)
Due to constant improvements, specifications are subject to change without notice.
Azden Corporation, 147 New Hyde Park Road, P.O. Box 10, Franklin Square, NY 11010
vox - 516.328.7500 • fax - 516.328.7506 • email - azdenus@azdencorp.com
© 2004 Azden Corporation
Printed in USA
100LT / 100HT SYSTEM
User's Guide
P1030-03
100UPR • 10BT • 10HT
ON-CAMERA
UHF WIRELESS MICROPHONE SYSTEM
Advertisement
Related Manuals for Azden 100HT
Summary of Contents for Azden 100HT
-
Page 1: Specifications
Approx. 130g Including Batteries (4.58oz) Due to constant improvements, specifications are subject to change without notice. Azden Corporation, 147 New Hyde Park Road, P.O. Box 10, Franklin Square, NY 11010 vox - 516.328.7500 • fax - 516.328.7506 • email - azdenus@azdencorp.com ©... - Page 2 Important information Licensing of this, or any Azden wireless equipment is the user’s responsibility. The ability to receive a license depends largely on the user’s classification, application and frequency. Contact the appropriate agency (FCC in the US) for further information.
- Page 3 If the sound is distorted lower the gain on the transmitter. If there is not enough volume raise the gain on the transmitter. Thank you for purchasing Azden’s 100LT or 100HT wireless system, which consists of the 100UPR receiver, 10BT transmitter and EX-503 lapel microphone or a 10HT transmitter.
- Page 4 BODYPACK TRANSMITTER (10BT) (1) Remove the battery compartment lid by sliding it down. (2) Insert one fresh alkaline 9V battery into the compartment. Make sure the battery polarity is correct as marked inside the battery compartment. In addition to the battery, inside the battery compartment you will find the following: (3-4) Frequency select With the frequency group dial on the left (3) you can select any of seven frequency groups (numbered from 0-6).