Axis 1650 Setup Instructions page 14

11 Scanning
Now you have prepared your computer for
scanning via AXIS 1650.
Note: These steps are just needed prior to the
first scanning from the computer.
Starting a Scan from the Canon Device
When you have established a connection be-
tween your computer and the scanner with
AXIS ScanClient, place the object to be
scanned on the scanner flatbed.
1. If the Canon device is in Energy Save
mode, press its [Energy Saver key].
2. Press [Scan] on the Canon device.
3. Press [Start] on the Canon device.
4. The scanning will start.
5. When ready, remove the scanned object
from the flatbed and walk back to your
computer.
6. Close the receiving program on your
computer and end the scanning session
(see below).
Note: When waking up from Power Off or En-
ergy Save mode the Canon device needs some
time (from 30 seconds to a few minutes) to
adjust the light and the scanner to produce
optimum scans. Press [Start] repeatedly until
scanning starts.