Advertisement
7. Secure mulch cover (item 8) onto weld screws with
two 5/16" flat steel washers (item 9) and two 1/4"
locking top flange nuts (item 10). Position mulch
cover over gap between deck opening and mulch
baffle. See Figure 7.
8
9
10
8. Lower unit to the ground.
9. Connect spark plug wire to spark plug.
Figure 7
MULCHING TIPS
For best mulching quality, follow these tips:
1. Mow at full throttle.
2. Mow at half speed.
3. Mow dry grass only. Mowing wet grass causes
clumping.
4. Keep mower blades sharp.
5. Cut no more than 1 in. (2.5 cm) at a time. For tall
grass, mow at a higher cutting height, then make a
second (or third) pass with the deck set to the
desired cutting height.
6. Clean the underside of deck after each mowing.
IMPORTANT: When cleaning, DO NOT wash with high-
pressure water. Allow all parts to cool before cleaning.
04447600B 6/13 Page 3 of 3
Advertisement
