Fault Finding; Replacement Parts; Wiring Diagram - Numatic CVC 370 Owner's Instructions Manual

Dry Mode maintenance/fault finding
If the vacuum cleaner stops working switch off and remove the plug from the wall before investigating were the fault
lies.
If the vacuum cleaner will not pick up any debris from the surface, switch off and remove the plug from the wall,
inspect the floor tool, wands and hose for blockages, if no blockages are found, the dust bag may be full if the dust
bag is not full the filter may be blocked.
Wet mode
If the vacuum cleaner stops working switch off and remove the plug from the wall before investigating were the fault
lies.
If the vacuum cleaner has a blockage and will not pick up liquid, switch off and remove the plug from the wall, has
the float valve operated, this will shut off the suction and the pitch of the vacuum motor will change.
Remove the power head and empty the liquid out of the container, if the container is empty, check that the floor tool
wands and hose are not blocked.
Flush the system with clean water after use.
After use always inspect the machine for damage.
604165
604016
604018
Motor AirFlo
1060W 49 L/sec
Capacity Capacity
Dry Wet
370: 15 Litres 9 Litres
380: 15 Litres 9 Litres
470: 27 Litres 20 Litres
TriTex Filter
HepaFlo Dust Bags
370 / 380 (NVM 2BH) Pack of 10
470 (NVM 3AH) Pck of 10
Suction
2400mm
Solution
Size (mm)
Tank
6 Litres 360 x 370 x 510
6 Litres 360 x 370 x 510
15 Litres 360 x 370 x 710

Replacement Parts

TriTex Filter
Cleaning Range
26.8m
Sound Pressure (LpA)
Uncertainty (KpA)
73-77 dB
0.2 dB (A)

Wiring Diagram

Fault Finding

Data
Class
II
Weight
9 Kg
9 Kg
9.6 Kg