MKS TFT28 Manual page 12

Web-Print Manual
V.
MKS WIFI Module Connection (only above MKS TFT28 V1.1 can support the function)
MKS TFT can support MKS WIFI module, which can be modified in the configuration:
Both MKS TFT28 and MKS TFT32 can use "network printing" function with MKS TFT-WIFI.
1. Web-Print Mode Introduction
1.1 Cloud Print Mode
It is recommended when router is available to Internet. Printer is ability to connect Cloud after
successfully configure network parameters of WIFI module. That you can powerful control your
printers by APP or MKS Cloud platform from anywhere around the world. Certainly, it is capable to
monitor printers by LAN on host-software, such as Printrun, proterface.
1.2 LAN Print Mode
If WIFI router can 't access to the Internet or at a slow speed, recommend this mode. You can
remote monitor of all your 3D printers. Start, stop, pause or edit prints, etc.
1.3 AP Mode
This mode will activate under following network environment.
a. Without wifi router.
b. WIFI is unconfigured.
c. WIFI is configuered, but unable to connect .
Then, the WIFI will generates a open hotspot "MKSWIFI-XXXX" which enter freely without password.
Support to control printers by APP, Web, Host-software.
12