Table of Contents
Advertisement
18. Make sure you wear close-fitting clothing that cannot easily get caught in the implement's
moving parts.
19. Never put your hands into the hopper of the seeder unit (optional). Always close the cover of
the hopper before using the implement and the seeder unit.
20. In case the milling unit is jammed, do not work on it while the loader is on. First of all follow
the routine described in point 1.
21. Use particular caution when driving on steep roads, or when using the implement on trails or
sloping ground.
22. If you drive on the road, observe the traffic regulations in effect in your country. Install the
required signal devices on the implement. Always check the maximum weight allowed on the
wheel axis. Use utmost caution: road handling, cornering stability and braking of the loader
may be different due to the presence and position of the implement. During the transport,
keep the implement in the lowest possible position and the nearest possible to the loader in
order to keep low the gravity centre.
23. The MILL GRADER mod. HI implement has been built for a precise work. It must always be
in perfect working condition and should be repaired using only original R2 spare parts.
24. Make sure all persons and animals are clear from the work area prior to powering up your
implement or during use.
25. For any intervention on the implement first remove it from the loader. Then, place the
implement flat on the floor or on flat supports and in a stable position.
26. All fluids under pressure, especially the hydraulic fluid, can provide serious skin lesions. In
this case consult immediately a doctor: risk of infection.
13
ENGLISH
13
Advertisement
Table of Contents
