Table of Contents
Advertisement
When using a DHCP server in your network environment
Configure settings on the "Easy" tab.
When using a DHCP server, changes to the "Advanced" tab (page 13) are unnecessary.
1 Click the "Browse" button, and specify the drive where the AIBO MIND 3
software "Memory Stick™" media is set (e.g. "E:" drive).
2 The name that you enter here will appear as the "AIBO Name" on the "AIBO
Search" tab (page 14). This name can be up to 8 alphanumeric characters and
must contain at least one letter.
3 Enter the network name (SSID) used by the wireless LAN access point.
(Maximum of 32 characters. Only alphanumeric characters and symbols are
allowed.)
4 Configure if using WEP (page 62). (If not using WEP, no settings are
necessary.) If using WEP, select the "Enable WEP Encryption" check box, and
enter the passkey (WEP)* for the wireless LAN access point. (Passkeys must
consist of alphanumeric characters or symbols. For [ASCII], the passkey must
be 5 or 13 characters. For [HEX], it must be 10 or 26 characters.)
Set the network authorization to "Open System".
Example Configuration
Alphanumeric
WEP64 (40 bit)
AIBO2
WEP128 (104 bit) ENTERTAINMENT
5 Confirm your settings, and click this button.
* To insure security, the encrypted passkey (WEP) is displayed with 13
asterisks (*) for ASCII and 26 for HEX, regardless of the number of characters
entered.
Hexadecimal
4149424f32
454e5445525441494e74d454e54
12
Advertisement
Table of Contents
