Hisense HBC54D6AS Use & Care Manual page 12

4.Unscrew the bottom right hinge screws as the
bottom left hinge screws.
Note: Keep the hinge for the future use.
Bottom left hinge
5.Flip the grille cover from left to right as following:
1. Pull it out from the left side slot.
2. Turn it 180 degree.
3. Put it into the right side slot.
grille
cover
grille
6.Reattach the grille cover to the beverage
cabinet as shown below.
7.Change the axle hole parts of as follows:
1. Pull out top right axle hole part by knife or thin
blade screwdriver.
2. Turn the door 180 degrees, face to the bottom of
the door and remove the reinforcement part and
magnet supporter with the screwdriver.
3. Put the top left axle hole part into the door hole.
4. Turn the door 180 degrees, Reattach the
reinforcement part and magnet supporter using
the same screws.
Note: Handle the door carefully. It is fragile.
1
3
Top left axle hole part
bottom right
hinge screws
Bottom right hinge
(as supplied)
magnet and
magnet supporter
the reinforcement part
and Hole sleeve
and screws
2
4
Top right axle hole part
(as supplied)
8.Turn the door 180 degrees, put the door on the
cabinet using the hinge and screws, on the top left
side. Use screw hole cover (right) to hide the holes
on the top right side of the beverage cabinet.
right upper hinge
and special flange
screw
Screw hole cover (right)
WARNING
When disposing of your appliance, use an
approved disposal site. Remove the plug
and ensure that any locks or catches are
removed, to prevent young children being
trapped inside.
Screw hole
cover (right)
Screw hole cover (left)
12