Hisense HBC54D6AS Use & Care Manual page 11

Reversing The Door
The side at which the door opens can be changed,
from the right side (as supplied) to the left side, if
required.
WARNING
When reversing the door, the appliance
must not be connected to power.
Ensure that the plug is removed from the
power socket.
The tools you will need (Not provided):
Not provided
8mm socket wrench Thin-blade Screwdriver
Phillips head screwdriver Adjustable Wrench
The parts you will need (provided )
Bottom left hinge Screw hole cover (right)
1
Note: If required you may lay the refrigerator on its
back in order to gain access to the base, you
should rest it on soft foam packaging or similar
material to avoid damaging the backboard of the
refrigerator. To reverse the door, the following steps
are generally recommended.
1.Stand the beverage cooler upright, close the door, use
a putty knife or thin-blade screwdriver to pry off the
screw hole cover which is at the top left corner of the
cooler, and unscrew the special flange screws which
are used for fixing the right upper hinge part by a 8mm
socket driver or a spanner (please support the upper
door with your hand when doing it).
Screw hole
cover (left)
11
Putty knife
8mm wrench
Top left axle hole part
1 1
special flange
screws
right upper
hinge
2. Move the door from the hinge by carefully lifting
the door straight up.
Note: When removing the door, watch for washer(s)
between the hinge and the bottom of the upper
door that may stick to the door. Do not lose these
washers.
3. Unscrew the grille cover fixing screws then lifting up
and pulling backwards, take the grille cover off the
cabinet.
Note: Take care of the screws. Record the screw's
place of use and quantity.
grille
door
2 screws here