Declaration Of Conformity; How To Dismantle System 2200 - PR 2220 Manual

DECLARATION OF CONFORMITY

As manufacturer
PR electronics A/S
Lerbakken 10
DK-8410 Rønde
hereby declares that the following product:
Type: 2220
Name: Switchmode power supply
is in conformity with the following directives and standards:
The EMC Directive 2004/108/EC and later amendments
EN 61326-1
For specification of the acceptable EMC performance level, refer to the
electrical specifications for the module.
The Low Voltage Directive 2006/95/EC and later amendments
EN 61010-1
The CE mark for compliance with the Low Voltage directive was affixed in the
year: 1997
Rønde, 7 October 2009
16
Kim Rasmussen
Manufacturer's signature

HOW TO DISMANTLE SYSTEM 2200

The back panel of the module is detached from the housing by way of a screw-
driver as shown in picture 1.
On a module with knobs, these may have to be removed before the PCB can be
taken out as shown in picture 2.
After this, the back panel can be pulled out together with the PCB, but please
notice the position of the PCB as there is a number of different positions in the
house. Do not pull the wires unnecessarily, instead pull the PCB, see picture 3.
Switches and jumpers can now be moved.
When assembling the back plate and housing, please make sure no wires are
stuck.
Picture 1: Dismantlement of back plate
and housing.
Picture 3: Removal of PCBs for adjustment of DIP-switches
and replacement of jumpers.
Picture 2: Removal of knobs.
17