Table of Contents
Advertisement
Showstopper 3 Base Reference Manual
Published 4-14-20
INSTALLATION
The Showstopper 3 Base is intended to be rack mounted in any standard 19" rack. Feel free to install
it along with other Showstopper devices, a rack PC, a storage drawer for the Showstopper 3
Consolette or in racks with your Stagehand controllers. It can also sit on the operator desk or on top
of a Stagehand controller - just be sure it is secured to avoid falling down or being accidentally
engaged.
MAKING THE CONNECTIONS
As with all our devices, they need to be connected to function.
INPUT POWER
Connect the IEC cable to mains power and to the Showstopper 3 Accessory Hub. The power
connection must be constant, loss of power to the Showstopper 3 Accessory Hub will stop all
movement to any connected Stagehands. We recommend adding in a Battery Backup to avoid
power loss issues.
ACCESSORY INPUT/OUTPUT
The Accessory output provides power (+24VDC) to the accessory devices as well as the Remote
E-Stop capability. This connection is a standard locking Harting connector (IRC 21mm x 21mm (3A)
12P 10A). This connection is designed to allow devices to be daisy chained together. However, at the
end of the chain, you must have a terminator to complete the e-stop circuit. Make sure that any
Accessory Output not connected to a device has a terminator.
Below is the pin-out for the Showstopper Accessory output:
Page 3 of 7
Advertisement
Table of Contents
