Bosch WTG86403UC Use And Care Manual / Installation Instructions page 36

Problem
Creasing.
Drying result is not sat-
isfactory (laundry feels
too damp).
Drying time too long.
Program does not start
Finish in (remaining)
time is displayed.
Program does not start
- symbol lit up.
D
One or more indicator
lights are flashing.
Power failure.
If troubleshooting did not solve your issue contact Customer Service ~ Customer service; Page 4
36
Possible cause(s)
Laundry load exceeded.
Unsuitable program selected.
Warm laundry may feel more damp
than it really is.
The selected program does not suit
the load.
Dryness level is not adjusted.
Fine layer of limescale or detergent
and textile care products residues
on the moisture sensors.
Program termination e.g. main
power supply failure, door open or
maximum drying time reached.
Initial load is too wet.
Lint filter and/or Condenser is dirty. Clean lint filter
Insufficient supply of ambient air for
cooling.
Air inlet possibly blocked.
Ambient temperature is lower than
° °
59 F/15 C or higher than 86
°
30 C .
A delayed starting time has been
selected and activated.
Childproof look is activated.
Lint filter or/and Condenser is dirty. Clean lint filter or/and Condenser (see solution of the
Installation conditions are not ade-
quate.
Fault in program sequence or mal-
function.
Solution(s)
Do not exceed the maximum load for selected pro-
gram. Remove items of laundry immediately after the
end of the program, hang them up and pull into shape.
Turn program selector to Off.
~ Program selection table; Page 28
Select Wrinkle Block button to prevent the laundry
from creasing or wrinkling.
~ Wrinkle Block; Page 29
Remove items of laundry immediately after the end of
the program and turn the program selector to Off.
Use another drying program or, in addition, select the
time program.
~ Program selection table; Page 28
Use Dry Level to adjust the dryness level.
~ Dry Level; Page 29
Clean the moisture sensors.
~ Cleaning the moisture sensors; Page 33
See the problem(s) mentioned in this table.
Spin laundry at higher speed in the washing machine,
before drying.
Switch off the dryer, and than turn it on again.
~ Cleaning the lint filter; Page 30
and/or Condenser.
~ Cleaning the Condenser; Page 32
Ensure that cool ambient room air can freely circulate
near the dryer.
~ Installation for best performance; Page 9
Do not obstruct the air inlet on the front of the dryer.
Ensure the ambient room conditions are within this
°
range.
F/
Drying cycle will begin at proper time to complete at
the selected Finish in time.
Deactivate Childproof look.
~ Childproof lock; Page 25
problem(s) in this table above).
Check the installation conditions.
~ Electrical Connections; Page 16
Switch off the dryer, allow it to cool down, switch back
on and restart the program.
Remove laundry from the dryer immediately and
spread out. This allows the heat to dissipate. Be care-
ful as the door, the drum and the laundry may be hot.