BENDIX SmartTire Quick Setup Manual

SmarTire
SAFETY
Follow all industry standard maintenance safety precautions, including wearing appropriate eye protection. See the
General Safety Guidelines on the other side.
IMPORTANT
This SmartTire TPMS kit is pre-programmed and ready to use, subject to your application:
™
● The sensors have been PRE-ASSIGNED TO WHEEL POSITIONS and are identified on each unit with a position
label (P1, P2, P3, etc.) – install the sensors as per the diagram below.
● Default values have been assigned to each axle for the following (depending on kit configuration):
► Cold Inflation Pressure (CIP) – preset to 100 PSI
► First Alert Level (FAL) – preset to ±15% from expected (temperature compensated) value
► Second Alert Level (SAL) – preset to -20% from CIP
► High temperature alert (optional) – 185°F (85°C)
INSTALLATION STEPS:
1. Install the receiver, display, antenna and harnesses on the vehicle, following the instructions in "Section D –
Installation Electrical" section of the SmarTire
2. Install the sensors in the pre-programmed locations as above, following the instructions in "Section E – Installation
Tire Sensors" section of the SmarTire
3. Adjust any system parameters as required, following "Section B – System Programming" section of the SmarTire
TPMS Operator's Manual.
Always protect your SmarTire
Use one fuse on the main power line, before the line branches out to each component.
This page is only a quick set up guide. For complete installation
instructions, download the SmarTire
from the Document Library, or the Literature Center, at www.bendix.com.
Quick Set Up Guide
Tire Pressure Monitoring System (TPMS) By Bendix CVS
™
™
TPMS Operator's Manual.
™
Tire Pressure Monitoring System with a (maximum) 5 amp fuse.
™
TPMS Operator's Manual (BW2799)
™
TPMS Operator's Manual.
NOTICE
™
1