Avocent AutoView AutoView 1400 Quick Installation Manual page 2

The following instructions will help you
connect your AutoView Wireless switch.
Should you require further assistance, please
consult your installer/user guide.
Notifications and Approvals
USA Notification
This device complies with part 15 of the FCC
rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference and (2) this device must
accept any interference received, including
received interference that may cause
undesired operation.
Agency Approvals
UL, cUL, FCC class A
To Contact Avocent Technical Support
Avocent, the Avocent logo, The Power of Being There and AutoView are registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. © 2004 Avocent Corporation. All rights reserved.
Quick Installation Guide
AutoView
To connect an AutoView Wireless receiver
3
Connect to an AC
power source.
2
Connect the
extended speaker.
Installing the AutoView Wireless receiver
(Repeat for each user in system)
Connecting the peripherals
Connect the extended user's keyboard, monitor and
mouse into the appropriately marked ports on the rear
of the receiver.
Connecting the audio
Connect your PC speakers into the receiver's audio
output connection.
CALL (888) 793-8763
®
Wireless Switch
Receiver
Powering up the receiver
Connect the power supply into the AutoView Wireless
receiver and into an AC power source.
For additional information
For further instructions on AutoView Wireless switch
hardware connection and switching, please refer to the
installer/user guide included with the unit.
EMAIL support@avocent.com
1
Connect the extended
user's keyboard,
monitor and mouse.
DOWNLOAD www.avocent.com
590-412-001A