Getting Started - VTech Peppa Pig Learning Watch Parents' Manual

GETTING START ED
POWER SOURCE
The Peppa Pig Learning Watch operates using a CR2450 battery. The CR2450
battery included with the product is for demo purposes only.
BATT ERY REMOVAL AND INSTALLATION
NOT E: For best performance, remove the factory-
installed battery from the Peppa Pig Learning Watch
and use a new battery.
1. Make sure the unit is turned Off.
2. Find the battery cover located on
the back of the unit, use a screwdriver to loosen the
screw and then open the battery cover.
3. Remove the old battery by pulling up on one end of
the battery.
4. Install one new CR2450 battery following the diagram
inside the battery cover.
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATT ERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATT ERI ES:
• Remove rechargeable batteries from the toy before charging
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
5 5
5