Troubleshooting; Battery Pack And Power - Sony DSLR-A200 Instruction Manual (DSLR-A200) Instruction Manual

Troubleshooting

If you experience trouble with your camera, try the following solutions.
Check the items on pages 143 to 151. Consult your Sony dealer or local
authorized Sony service facility.
Check the following items.
1
Remove the battery pack, and insert the battery pack again after
2
about one minute, and turn on the power.
Reset the settings (page 116).
3
Consult your Sony dealer or local authorized Sony service facility.
4

Battery pack and power

The battery pack cannot be installed.
• As you insert the battery pack, use the tip of the battery pack to push the
lock lever (page 16).
• Check the model number of the battery pack.
The battery remaining indicator is incorrect, or sufficient battery
remaining indicator is displayed but the power runs out too quickly.
• This phenomenon occurs when you use the camera in an extremely hot or
cold location (page 154).
• The displayed battery remaining differs from the current one. Fully
discharge and then charge the battery pack to correct the display.
• The battery pack is discharged. Install a charged battery pack (page 16).
• The battery pack is dead (page 18). Replace it with new one.
Cannot turn on the camera.
• Install the battery pack correctly (page 16).
• The battery pack is discharged. Install a charged battery pack (page 16).
• The battery pack is dead (page 18). Replace it with new one.
143