Advertisement
Quick Links
(16)
A
(4)
B
(4)
C
(4)
D
(4)
E
(6)
F
(8)
G
(8)
H
(8)
I
(1)
J
ALLEN WRENCH
( included )
Item No: MHYA-DCC - S - R
HYANNIS COUNTER SWIVEL CHAIR
Hardware and Parts
1.50
3.50
2.75
2.50
2.00
1.50
(Right Arm)
Assembly
(Seat Bottom)
Assembly
Do not use
any hand drill
on this product
Assembly Instructions
( Seat Back Assembly )
Arm
R
K
T
N
(Foot rest
1, 2, 3, & 4)
(Leg 1,2,3 & 4)
You will also need a phillips-head screwdriver
( not included )
Item No: MHYA-DCB - S - R
HYANNIS BAR SWIVEL CHAIR
Q
(Under Arm
Brace)
(Left Arm)
Assembly
P
(Base Swivel)
Plate
M
WRENCH
( not included )
S
L
Advertisement
Related Manuals for Malibu Boats HYANNIS COUNTER SWIVEL CHAIR MHYA-DCC-S-R
Summary of Contents for Malibu Boats HYANNIS COUNTER SWIVEL CHAIR MHYA-DCC-S-R
- Page 1 Assembly Instructions Item No: MHYA-DCC - S - R Item No: MHYA-DCB - S - R HYANNIS COUNTER SWIVEL CHAIR HYANNIS BAR SWIVEL CHAIR Hardware and Parts 1.50 (16) 3.50 2.75 ( Seat Back Assembly ) 2.50 2.00 (Under Arm Brace) 1.50 (Right Arm)
- Page 2 Figure 1 1a - Attach part ( S ) under arm brace to part ( K ) front right side ( FR ) & Rear right side ( RR ) legs using 4 of screws. ( G ) 2 for each leg. Tighten screws using a phillips-head screwdriver. Be sure to lay the legs and arm brace on a flat clean surface to assemble.
- Page 3 Figure 2 2,a - To Attach part ( Q ), seat back assembly , to part ( J ), seat bottom assembly as shown, you must align the lower front edge of yoke to the front edge of groove, ( Seat Back Assembly ) see detail 1.
- Page 4 Figure 4 4 - Attach part ( M ), Leg 1, to part ( P ), base swivel plate, as shown in Figure 4, see detail 6, using ( 2 ) of lag screws ( H), tighten screws using an allen wrench . ( Detail 6 ) (Base swivel Plate)
-
Page 5: Care And Maintenance
Figure 8 8 - Attach part ( M ), leg 3, to assembly from figure 7 as shown in Figure 8, see detail 11 and detail 12. (detail 11) - using ( 1 ) of screws ( I ), tighten screw using a phillips-head screwdriver. (detail 12 ) - using ( 2 ) of lag screws ( H ), tighten screws using an allen wrench.