Technical Data; Maintenance; Guarantee - PRO USER ACCESSORIES SNEPP ALU Assembly Instruction And Safety Regulations

accordingly (max 120km/h). Try to avoid sudden braking and steering
movements.
 Check the roof rack before use if there is any damage. Damaged or worn
parts need to be replaced immediately. Only use original replacement parts.
 Do not make any modifications on the roof rack. This can be very dangerous.
 In case of defects or problems please contact your Pro-User supplier.

TECHNICAL DATA

Oval profile (aluminium): ~28,2x47,9mm
Min. rail height: 30mm
Max. roof rail thickness: 58mm
Bar lengths: ca. 120cm
Max. rail spacing: up to 1,07m centre
Own weight: 3,2kg
Load capacity: 75kg/90kg (depending on type of car)

MAINTENANCE

 Check the roof rack regular if there is any damage. Damaged or worn parts
need to be replaced immediately. Use only original replacement parts.
 In case of accidental fall of the accessory, check immediately to make sure
there is no damage such as cracks, or visible dents that would affect the
correct working of the accessory. In such cases, replace the damaged part or
the accessory.
 Always store the roof rack clean and dry after use. If necessary spray with the
water hose to remove mud and other filthy stuff.
 The nuts and bolts of the roof rack need to be checked regular, if necessary
tighten them again.

GUARANTEE

This product is covered by a 2 year guarantee. Please note that our guarantee
covers reasonable use of the roof rack, it does NOT cover any damage caused by
misuse. This also applies to a malfunction or failure of the roof rack that has
been caused by poor or incorrect installation. To ensure the validity of the
guarantee please carry out maintenance in accordance with the maintenance
section. We reserve the right to make a call out and/or repair charge for any
work required to be undertaken to rectify faults that are outside of the
company's control i.e. incorrect or poor fitting, misuse, accidental damage, etc.