Introduction; Assembly Instructions - PRO USER ACCESSORIES SNEPP ALU Assembly Instruction And Safety Regulations

INTRODUCTION

Dear Consumer, thank you for having chosen a Pro-User product. This
accessory has been designed, constructed and tested carefully, in
compliance with all the stringent standards in force.
Please read the following information carefully for your safety and that of
all travellers.
Always comply with the laws in force in the country of use.
Preserve this booklet, specifically, the Installation
Manual of your accessory in your car. Read the
Instruction Manual carefully before assembling and
fitting the accessory as well loading.

ASSEMBLY INSTRUCTIONS

A. Open the red lock (in the round opening for Allen key) with the key on the
side of the rail clamp. Loosen the rail clamp with the Allen key.
B. The rail clamp is now open and flexible to move on the rail.
C. Place the roof bar symmetrically onto the railings. Equalize the roof bar
clearances (approx. 70cm) to each other.
D. Tighten the rail clamps with the Allen key. Check the roof bar is tightly in
place by pulling forwards and backwards. If necessary, retighten the rail
clamp screws.
E. Lock the roof rack again with the key on the side of the rail clamp.