Sealey SAC05020 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. sAfetY
1.1. electricAl sAfetY
WArNiNG! It is the user's responsibility to check the following:
‰
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCd (Residual Current device) is used with all electrical
products. You may obtain an RCd by contacting your local Sealey stockist.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
electrical safety information, it is important that the following information is read and understood.
ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
do Not pull or carry the appliance by the power cable.
8
do Not pull the plug from the socket by the cable.
8
do Not use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired or is
8
replaced immediately by a qualified electrician.
This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Ensure that repairs are carried out by a qualified electrician.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
a) Connect the GREEN/YELLOW earth wire to the earth terminal 'E'.
b) Connect the BROWN live wire to the live terminal 'L'.
c) Connect the BLUE neutral wire to the neutral terminal 'N'.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
Sealey recommend that repairs are carried out by a qualified electrician.
If an extension reel is used it should be fully unwound before connection. A reel with an RCd fitted is
preferred since any appliance plugged into it will be protected. The cable core section is important and should be at least 1.5mm², but to
be absolutely sure that the capacity of the reel is suitable for this product and for others which may be used in the other output sockets,
we recommend the use of 2.5mm² section cable.
1.2. GeNerAl sAfetY
Familiarise yourself with the application and limitations of the compressor.
9
Ensure the compressor is in good order and condition before use. If in any doubt do not use the unit and contact an electrician/service
9
agent.
WArNiNG! Compressor must only be serviced by an authorised agent. DO NOT tamper with, or attempt to adjust, pressure
‰
switch or safety valve.
Before moving, or maintaining the compressor ensure it is unplugged from the mains supply and that the air tank pressure has been
9
vented.
only use recommended attachments and parts. To use unapproved items may be dangerous and will invalidate your warranty.
9
Read the instructions regarding any accessory used with the compressor. ensure the safe working pressure of any air appliance used
9
exceeds unit's output pressure. If using spray gun, check that the area selected for spraying is provided with air change system/ventilation.
ensure the air supply valve is turned off before disconnecting the air supply hose.
9
To move the compressor use the handle only.
9
Use the compressor in a well ventilated area with a temperature above 5°C, and ensure it is placed on a firm, level surface.
9
Keep tools and other items away from the compressor when it is in use, and keep area clean and clear of unnecessary items.
9
ensure any air hose attached is not tangled, twisted or pinched.
9
Keep children and unauthorised persons away from the working area.
9
do Not dis-assemble compressor for any reason. The unit must be checked by qualified personnel only.
8
do Not use the compressor outdoors, or in damp, or wet, locations and do Not operate within the vicinity of flammable liquids,
8
gases or materials.
© Jack Sealey limited
50 l oil free belt drive compressor 2hp
model no:
Wear ear
WArNiNG!
ensure oil
protection
level is correct High Voltage
before first
use
Original Language Version
sAc05020
WArNiNG!
Hot surface
WArNiNG: Indoor use only
Automatic
start up
Recommended fuse rating
SAC05020 | Issue:3 (H,F) 01/08/19
do Not
open the air
cock before
an air hose is
attached
13 Amp