Table of Contents
Advertisement
8
Clamping screw on
quick-release axle in
wheel carrier
108
14 lb/ft (19 Nm)
Remove front wheel stand.
Ease brake calipers onto brake
disks.
z
The cable of the ABS sen-
sor could chafe through if
it comes into contact with the
brake disk.
Make sure that ABS sensor cable
is routed correctly.
Carefully route ABS sensor ca-
ble. When doing so, make sure
ABS sensor cable is clipped
into retaining clips 8.
Install securing screws 3 on left
and right with specified torque.
Front brake caliper on
wheel carrier
22 lb/ft (30 Nm)
Remove adhesive tape from
wheel rim.
Press handbrake lever firmly
a number of times until resis-
tance point is felt.
Install front mudguard and
screws 1 on left and right.
Remove rear wheel stand if
necessary.
Removing rear wheel
Place motorcycle on an auxil-
iary stand; BMW Motorrad rec-
ommends BMW Motorrad rear
wheel stand.
Installing rear-wheel stand
(
113)
With OA Center stand:
Make sure ground is level and
firm and place motorcycle on
its center stand.
Advertisement
Table of Contents
