Advertisement
4. Thread or push one or two auxiliary contacts and wires through the rear of the connector before inserting into auxiliary housings.
Push into auxiliary housings through rear until notched side of contact tip snaps over spring. Tug wires to make sure wires are secure.
Figure 1
Male Dovetail
5. Slide two auxiliary Powerpole
housing. The rear of each of the Powerpole housings must be fl ush.
6. Slide stacked auxiliaries back into connector housing until seated. The male dovetail should be on top as shown in (fi gure 1). Make
sure side grooves of auxiliaries are aligned for retaining pins and insert tubular pins. Tap pins in holes from top, as shown in (fi gure 1).
7. Cable ties are supplied to secure the auxiliary leads or cable to one of the main power cables. Leave slack or loop in leads to
Powerpole
contacts when applying cable ties. Wraps to be placed approximately 1 inch (25.4 mm) apart as shown in (fi gure 2).
®
Figure 2
Loop Wire
[25]
1.0
8. To remove auxiliary housings, punch out retaining pins from bottom of the connector housing with an 0.06 inch (1.5 mm) diameter
steel rod or pin driver. Pull auxiliary housings out of the SBE
number 111038G2), to remove contacts from auxiliary housings see (fi gure 3).
Figure 3
WARNING: UTMOST CAUTION SHOULD BE USED WHEN WORKING ON LIVE CONNECTOR CONTACTS
UL and CSA Reference - These connectors are recognized under the component program of Underwriters' Laboratories, File E26226,
as well as Canadian Standards Association, Report LR25154.
© 2019 Anderson Power Products, Inc. All rights reserved. APP
the APP Logo are registered trademarks of Anderson Power Products, Inc. Anderson™ is a trademark of Anderson Power Products, Inc.
Anderson™ will use reasonable efforts to include accurate and up-to-date content in the assembly instruction. All product information
contained in the instruction sheet including ordering information, illustrations, specifi cations, and dimensions, are believed to be reliable
as of the date of publishing, but is subject to change without notice. Anderson™ makes no warranty or representation as to its accuracy.
Content in the instruction sheet may contain technical inaccuracies, typographical errors and may be changed or updated without notice.
Anderson™ may also make improvements and/or changes to the products and/or to the programs described in the content at any time
without notice. Current sales drawings and specifi cations are available upon request.
HEADQUARTERS: Anderson Power Products®, 13 Pratts Junction Road, Sterling, MA 01564-2305 USA
All Data Subject To Change Without Notice
Retaining Pin
Top
housings together by dovetails to stack vertically. They cannot be inserted separately into SBE / SBX
®
/SBX
connector housing. Use contact insertion-extraction tool kit (part
®
®
, A
, Anderson Power Products
®
®
, SBE
, SBX
, SBO
, Powerpole
®
®
®
®
www.andersonpower.com
2019-0013, 1S6556 REV 4
and
®
Advertisement
