Table of Contents
Advertisement
Installation
e
w
6 Remove the Bezel
Bezel
q
Countersunk Holes
w
6. Remove the bezel from the steering wheel shaft,
taking care to leave the attachment screws in the
countersunk holes in the bezel.
q
w
e
7 Attach the Bezel
Bezel
q
Switch Assembly
w
7. Attach the switch assembly to the bezel using the
screws provided:
a. If the bezel has no recessed holes, use two
7/16 in. screws and lock nuts (provided).
b. If the bezel has recessed holes, use two 5/8 in.
self-tapping screws (provided).
6
q
Steering Wheel Shaft
e
r
Screws
e
Steering Wheel Shaft
r
PRO TRIM™ Single/Dual Bezel Switch Assembly
8. Depending on the option chosen in step 4, feed the
wires:
– Through the bezel and dash.
– Through the dash.
– Underneath the dash.
9. Place the bezel with attached switch assembly over
the steering wheel shaft (see Figure 7) and tighten
the bezel attachment screws.
10. Proceed to "Wiring the Connections to the Marine
Craft Device" on page 11.
5 .2 Mounting on a Rack Steering
System (Non-Tilt)
q
8 Rack Steering System Bezels
Rack Steering System
q
Bezel
The helm of the Rack Steering System (1984–present)
can be identified by the plastic bezel (trim piece)
through which the steering wheel shaft passes.
1. Remove the steering wheel and retain the hardware
for use during reinstallation. Refer to your steering
system and wheel manufacturer instructions to
ensure proper removal of the steering components.
w
Back Mount Rack
w
Steering System
Bezel
EN
Advertisement
Table of Contents
