Table of Contents
Advertisement
PRO TRIM™ Single/Dual Bezel Switch Assembly
5 .1 Mounting on an Xtreme or No
Feedback (NFB) Rotary Steering
System (Non-Tilt)
q
3 Xtreme and NFB Rotary Steering System Bezels
NFB and
q
Xtreme Bezel
(90° Orientation)
The helm of the Xtreme Rotary Steering System (2012–
present non-tilt) and the NFB Steering System (1990–
present non-tilt) can be identified by the plastic bezel
(trim piece) through which the steering wheel shaft
passes.
1. Remove the steering wheel and retain the hardware
for use during reinstallation. Refer to your steering
system and wheel manufacturer instructions to
ensure proper removal of the steering components.
q
4 Rotary Steering System Drill Locations
Rotary Steering System Drill Locations
q
2. Place the switch assembly bracket against the plastic
bezel and mark the holes indicated in Figure 4.
3. Drill two 3/16 in. diameter holes where marked on
the plastic bezel.
EN
w
NFB Bezel
w
(20° Orientation)
q
I
If your bezel already has recessed holes at these
locations, then no drilling of the bezel is necessary.
q
w
5 Rotary Steering System Wire Passage—Options 1 and 2 Holes
Option 1 Holes
q
4. Provide a passageway for the wires to the inside or
underside of the dash. This can be done one of three
ways:
Option 1. Allow the wires to pass through the dash
while concealed by the bezel:
a. Drill one or two 3/8 in. diameter holes
(one required for single switch; two
required for dual switch) in the beveled
face of the bezel.
b. Drill 3/8 in. diameter holes in the dash.
Option 2. Allow the wires to pass through the dash
and not be concealed by the bezel. Drill
one or two 3/8 in. diameter holes (one
required for single switch; two required for
dual switch) through the dash.
Option 3. Allow passage of the wires underneath the
dash. Drilling holes is not required.
I
If installing a single switch, be sure the hole(s) is
drilled on the side the switch lever will be installed.
5. Attach the wires to the switch; red wire to the center
terminal, green wire to the top terminal, and blue
wire to the bottom terminal (see Figure 2).
Installation
w
q
Option 2 Holes
w
5
Advertisement
Table of Contents
