Page 3
Preface Thank you for placing your trust in this ELSA product. With the ECOMO 20LCD99 you have selected one of ELSA's high-end monitors. ELSA products are subject to the high- est of standards in production and quality control which are the foundation for consis- tently high product quality.
Troubleshooting ......................19 Messages on Display.................... 19 POWER-SAVE Function is 'Off'................. 20 POWER-SAVE Function is 'On' ................. 20 POWER-SAVE Function either 'On' or 'Off' ............20 Appendix ........................21 TCO '99........................21 ELSA ServiceDirect ....................24 Warranty conditions....................25 ECOMO 20LCD99...
The system can only perform this function if both the monitor and the computer (the graphics board) are support with the DDC function. The ECOMO 20LCD99 has a multilevel power save function which reduces power consumption when the monitor is not in use. ELSA ECOMO 20LCD99...
Do not clean the device with benzene, thinner or other volatile substances because the surface could get damaged. Never leave the monitor in contact with rubber or vinyl prod- ucts for an extended time period. ELSA ECOMO 20LCD99...
ECOMO 20LCD99 . Caution to the user: The Federal Communications Commission warns the user that changes or modifications to the unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. ELSA ECOMO 20LCD99...
Once you have unpacked the ECOMO 20LCD99 you should check if anything is missing. The scope of supply includes: ´ ³ ¿ · » Monitor ELSA ECOMO 20LCD99 Power supply cord Power supply adapter User's Guide Data media ELSA ECOMO 20LCD99...
The monitor's power supply adapter remains active when the device is switched off. Therefore, the power socket should be close to the device and easily accessible. Do not use the power supply adapter for other devices as this can cause damage or fire! ELSA ECOMO 20LCD99...
Adjust – You can modify the settings on the selected OSD menu page with these keys. ¿ Power switch – Switches the monitor on and off. ´ Power indicator– This indicator lights up when the monitor is switched on. ELSA ECOMO 20LCD99...
If you press one of the SELECT keys on the monitor's keypad, the OSD menu will appear on the screen. Use the keys to access the individual menu pages within the OSD menu. ELSA ECOMO 20LCD99...
SELECT Adjust values and functions by pressing the +/- buttons. ADJUST After ten seconds of inactivity, the OSD screen automatically disappears. Press the fol- lowing button combination to switch the OSD off immediately. SELECT ELSA ECOMO 20LCD99...
Page 16
Operating and Adjusting ELSA ECOMO 20LCD99...
Language The ECOMO 20LCD99 can display its on-screen menus in a variety of languages. To change the language used for the on-screen menu, simply call up the menu page illustrated here and select the language you want. ELSA ECOMO 20LCD99...
Full screen To off the fullscreen mode. To on the fullscreen mode. Auto select To off the auto select To on the auto select function. function. All reset – To restore to the factory preset mode. ELSA ECOMO 20LCD99...
SELECT or ADJUST keys. When the OSD menu is removed from the dis- play, you can access the CONTROL-LOCK page Then press the '+' key to lock the OSD again and remove the lock by pressing the menu. minus key. ELSA ECOMO 20LCD99...
Page 20
Registration and Configuration ELSA ECOMO 20LCD99...
ISO 9241-3 , ISO 9241-8 (TÜV Ergonomics approved) ZH1/618 (TÜV/GS) NUTEK Spec. 803299/94 * As an Energy Star Partner, ELSA AG has determined that this product meets the Energy Star guidelines for energy efficiency. The Power Save Function The ECOMO 20LCD99 corresponds to the VESA and EPA Energy Star guidelines and the strict NUTEK requirements.
Video BLUE Video RED Sense 2 C-Sync C & V Sync. ground Sense 0 V-Sync. Video GREEN (mono video) Ground BLUE Ground GREEN H-Sync. ground Sense 1 H-Sync. unused H-Sync. = line frequency, V-Sync. = refresh frequency ELSA ECOMO 20LCD99...
Troubleshooting Troubleshooting Before you refer to ELSA support please check the connections and settings below. Problem Check What should I do? LED on Are contrast and brightness set to Increase brightness and contrast picture minimum levels? values or press the reset button LED off –...
CHECK INPUT SIGNAL OR CONNECTION POWER-SAVE Function either 'On' or 'Off' If the signal frequency is outside the possible range the following message is displayed: ATTENTION SIGNAL FREQUENCY IS OUT OF RANGE 96.8KHz 73Hz PLEASE CHANGE SIGNAL TIMING ELSA ECOMO 20LCD99...
The product must be prepared for recycling and the manufac- turer is obliged to have an environmental policy which must be adhered to in each country where the company implements its operational policy. ELSA ECOMO 20LCD99...
Page 28
Mercury* * Mercury is sometimes found in batteries, relays and switches. It damages the nervous system and is toxic in high doses. The relevant TCO'99 requirement states ELSA ECOMO 20LCD99...
Page 29
TCO´99 requirement permits the inclusion of lead since no replacement has yet been developed. * Bio-accumulative is defined as substances which accumulate within living organisms ** Lead, cadmium and mercury are heavy metals which are bio-accumulative. ELSA ECOMO 20LCD99...
Terms of Warranty, valid for the Federal Republic of Germany (refer to our Internet site: www.elsa.com). f the ELSA service cannot find fault with the unit claimed to be defective, we will invoice you for DM 200 plus V.A.T. to cover inspection costs and replacement of the unit.
Appendix Warranty conditions The ELSA AG warranty, valid as of June 01, 1998, is given to purchasers of ELSA products in addition to the warranty conditions provided by law and in accordance with the following conditions: Warranty coverage The warranty covers the equipment delivered and all its parts. Parts will, at our sole discretion, be replaced or repaired free of charge if, despite proven proper handling and adherence to the operat- ing instructions, these parts became defective due to fabrication and/or material defects.
Page 32
ELSA Monitor, damage to the cathode ray tube (CRT) has been caused especially by mechanical load (e.g. from shock to the pitch mask assembly or damage to the glass tube), by...
Need help?
Do you have a question about the ECOMO 20LCD9 and is the answer not in the manual?
Questions and answers