1. AVVERTENZE PER LA SICUREZZA L’installazione del prodotto deve essere eseguita da personale qualificato in conformità alle leggi e normative locali sulla sicurezza e nel rispetto del D.M. 37/08 (D.M. 22 gennaio 2008 n°37) e dei successivi aggiornamenti. L’utilizzo del prodotto deve avvenire nel pieno rispetto delle istruzioni d’uso contenute nel presente manuale.
2. DESCRIZIONE DEL PRODOTTO Il ricevitore OPT-RX DT TV converte il segnale ottico in un’unica uscita RF, mettendo a disposizione degli utenti il segnale TV terrestre e una polarità SAT con tutti i servizi e contenuti offerti dai broadcaster, come se fossero direttamente connessi alla propria antenna.
4.1 Dimensionamento di un impianto in fibra ottica Il ricevitore OPT-RX DT TV garantisce un adeguato livello del segnale TV e SAT alla presa utente se il segnale ottico al suo ingresso è compreso tra -8dBm e -14dBm ottici e il segnale RF in ingresso al trasmettitore (OPT-TX DT, KTX o OPT-TX51) rispetta le indicazioni riportate nel manuale del trasmettitore.
5. SPECIFICHE TECNICHE OPT-RX DT TV Fracarro code 270696 CONNECTORS Optical input connector Type FC/PC /patch cable SC/APC Input connector (for loop through) Type F female Output connector Type F female OUTPUTS Output bandwidth TV: 87 ÷ 862 SAT: 950 ÷ 2150 TV Output power level dBµV...
Page 6
6. ESEMPI TIPICI DI IMPIANTO Alcuni schemi di esempio sono disponibili nelle ultime pagine del manuale e nel sito www.fracarro.com 7. CONFORMITA’ ALLE NORMATIVE EUROPEE Il prodotto OPT-RX DT TV è conforme alle norme: EN 50083-2 (direttiva europea 2004/108/EC – EMC)
1. SAFETY WARNINGS The product must be installed by a qualified engineer, according to the local safety standards and regulations. The product is classified as Class II, in accordance with EN 60065, and for this reason it doesn’t need to be connected to the protective earth (PE) of the mains supply. Installation warnings •...
2. PRODUCT DESCRIPTION OPT-RX DT TV converts the optical signal into a single RF output, providing users with TV terrestrial signal and 1 SAT polarity with all the services and content offered by broadcasters, as if they were directly connected to the antenna.
Page 9
Please note that 1dB optical loss is equivalent to 2 dB of attenuation at the electrical level (RF). Below some reference levels are given for the output signals to the OPT-RX DT TV receiver Note: the level of the output signal can be adjusted using the trimmer (0-20dB).
Green light means module is powered Operating temperature °C -5 ÷ 50 Compliance EN50083-2, EN60065 7. EUROPEAN DIRECTIVES CONFORMITY The product OPT-RX DT TV complies with the standard: EN 50083-2 (European directive 2004/108/EC - EMC) EN 60065 (uropean directives EMC, 2006/95/EC - LVD)
Page 11
(see chapter 4). • Optical levels shown in the following designs are calculated using the typical attenuation values for the passive components used. Schema con trasmettitore KTX e ricevitori OPT-RX DT TV Scheme with KTX transmitter and OPT-RX DT TV receivers...