Removing Clogs In Auger Housing Or Discharge Chute - Generac Power Systems GC2800B Owner's Manual

Operation
Removing Clogs in Auger Housing or
Discharge Chute
WARNING
Personal injury. Before performing any maintenance
procedure or inspection, stop the engine, remove key, and
allow unit to cool. Failure to do so could result in death,
personal injury, or property or equipment damage.
Proceed as follows to remove clogs in auger housing or
discharge chute:
1. See Figure 3-7. Use shovel (A) to clean snow from
discharge chute or auger housing.
Figure 3-7. Clearing Clog
2. Start unit to clean out any remaining material and
repeat cleaning process as needed until snow dis-
charges freely.
16
(000727)
A
011097
Owner's Manual for Snow Blower