Assembly Instructions - Generac Power Systems GC2800B Owner's Manual

General Information and Setup
2. Contact Generac Customer Service at 1-888-436-
3722 (1-888-GENERAC), or
with the unit model and serial number for any miss-
ing carton contents.
3. Record model, serial number, and date of pur-
chase on front cover of this manual.

Assembly Instructions

Proceed as follows to assemble unit:
1. See Figure 2-5. Position handlebar assembly (A)
behind snow blower (B) in a flat, clean area.
E
Figure 2-5. Handlebar Assembly
2. Move plastic covers (C) away from cable spring
hooks (D).
3. Attach cable spring hook of drive control cable (E)
into pulley wire on left side of unit.
4. Attach spring hook of auger control cable (F) into
the tension connector on right side of unit.
5. See Figure 2-6. Have a helper hold upper handle-
bar assembly in position on lower handlebar (G).
Figure 2-6. Upper and Lower Handlebar Assembly
8
www.generac.com
D
F
C
011052
G
011051
6. See Figure
upper and lower handlebar assemblies and secure
with M8 X 55 bolts, 8 X 22 X 2 washers (J) and M8
jam nuts (K) using a 13mm wrench.
NOTE: Verify bolt heads are on the outside of the han-
dlebar and the square portion of the bolts go fully into the
squares in the handlebar.
K
B
J
Figure 2-7. Adaptor Plate Assembly
A
7. See Figure
nuts (L) on auger control cable and drive control
cable to verify tightness. Tighten as needed using
a 6mm wrench to hold the cable and an 8mm
wrench to tighten the jam nut.
Figure 2-8. Control Cable Jam Nut
2-7. Place adaptor plates (H) between
H
2-8. Lift plastic covers and inspect jam
L
Owner's Manual for Snow Blower
I
011053
011054