Advertisement
(3) Remove the short-circuit connector from CN4F
on the control board (white, 4P). (Fig. 8)
(4) Route the two drain pump wires behind the CON-
TROL BOX and into the CONTROL BOX.
Lift the CONTROL BOX in the direction of the
arrow (d) to allow the wires through. (Fig. 8)
Do not pinch the wires.
(5) Wind the drain pump wire (connector: blue, 3P)
around 9FERRITE CLAMP once, and fix it in
place with 0 BAND. (Fig. 9)
(6) Connect the drain pump wire (connector: blue,
3P) to CNP on the control board, and connect the
float switch wire (white: 4P) to CN4F on the con-
trol board respectively. (Fig. 8)
(7) Place the screw(c) that was removed in Step 3-
3.(2) above back on. (Fig. 7)
(8) Fix the two drain pump wires with 8 CLAMPs to
the unit. (Fig. 10)
Drain pump wires (2 wires)
Drain pump wire(2 wires)
8CLAMP
Fig. 10
5
Short-circuit connector
CN4F
(d)
Fig. 8
@ BAND
9FERRITE CLAMP
20
Fig. 9
CNP
Blue:3P
Advertisement
