Adjusting The Cutting Angle - Makita LS1045 Instruction Manual

Adjusting the cutting angle

This tool is carefully adjusted and aligned at the factory,
but rough handling may have affected the alignment. If
your tool is not aligned properly, perform the following:
1. Miter angle
1
011919
Loosen the grip which secures the turn base. Turn
the turn base so that the pointer points to 0° on the
miter scale. Tighten the grip and loosen the hex
bolts securing the guide fence using the socket
wrench.
Lower the handle fully and lock it in the lowered
position by pushing in the stopper pin. Square the
side of the blade with the face of the guide fence
using a triangular rule, try-square, etc. Then
securely tighten the hex bolts on the guide fence in
the order from the right side.
3
011918
2. Bevel angle
(1) 0° bevel angle
1
001768
Lower the handle fully and lock it in the
lowered position by pushing in the stopper pin.
Loosen the lever at the rear of the tool.
Loosen the hex nut and turn the 0° bevel
angle adjusting bolt on the right side of the
1. Hex bolts
1. Triangular rule
2. Grip
3. Guide fence
1
2
1. Arm
2. Lever
3. 0 ﾟ adjusting
2
bolt
4. Hex nut
3
4
turn base two or three revolutions clockwise
to tilt the blade to the right.
Carefully square the side of the blade with the
top surface of the turn base using the
triangular rule, try-square, etc. by turning the
0° bevel
counterclockwise. Then tighten the hex nut to
secure the 0° bevel angle adjusting bolt and
tighten the lever securely.
1
001819
Make sure that the pointer on the turn base
point to 0° on the bevel scale on the arm. If it
does not point to 0°, loosen the screw which
secures the pointer and adjust the pointer so
that it will point to 0°.
1
001769
(2) 45° bevel angle
1
2
001770
Adjust the 45° bevel angle only after
performing 0° bevel angle adjustment. To
adjust left 45° bevel angle, loosen the lever
and tilt the blade to the left fully. Make sure
that the pointer on the arm points to 45° on
the bevel scale on the arm. If the pointer does
not point to 45°, turn the 45° bevel angle
adjusting bolt on the left side of the arm until
the pointer points to 45°.
12
angle adjusting
1. Triangular rule
2. Saw blade
3. Top surface of
2
turn table
3
1. Arm
2. Bevel scale
3. Pointer
4. Turn base
4
2
3
1. Lever
2. Arm
3. Pointer
4. 45 ﾟ bevel angle
adjusting bolt
4
3
bolt