Advertisement
Quick Links
Advertisement
Related Manuals for impact BP-RA-MBH
Summary of Contents for impact BP-RA-MBH
- Page 1 BP-RA-MBH Right Angle Baby Plate with Mini Ball Head INSTRUCTIONS...
-
Page 2: Specifications
Introduction Thank you for choosing Impact. The BP-RA-MBH Right Angle Baby Plate securely mounts a camera or camcorder onto a wall. Its 8-inch baby pin can support a camera and lens combination that weigh up to 6 pounds, and the included mini ballhead lets you precisely adjust the camera’s angle and the distance from the wall. - Page 3 Overview 1. Screw holes You’ll Also Need 2. Ballhead locking knob 3. 1/4-20 mounting bolt • Wall fasteners (anchors and 4. Mini ballhead screws, molly bolts, or toggle bolts) 5. Baby pin 6. 5/8 in. receiver • Drill bit (see the fastener’s 7.
-
Page 4: Installation Instructions
Setup Installation Instructions 1. Use the wall plate to mark the position of the mounting holes on the wall. 2. Drill holes in the marked locations. Make appropriately sized holes for the wall anchors, molly bolts, or toggle bolts. If you’re using wall anchors, tap the anchors into the holes. - Page 5 4. Slide the mounting block onto the baby pin, and tighten the locking knob until secure. You can attach the mounting block horizontally or vertically, via the 5/8-inch receivers on the sides (4a) or the bottom (4b) of the block. 5.
-
Page 6: One-Year Limited Warranty
One-Year Limited Warranty This Impact product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of one (1) year from the original purchase date or thirty (30) days after replacement, whichever occurs later. The warranty provider’s responsibility with respect to this limited warranty shall be limited solely to repair...