Audiovox CE445C Operating Instructions

PRECAUTIONS
Follow the advice below for safe and appropriate operations.
ON PLACEMENT ON SAFETY
• Do not use the unit in places • When
which are extremely hot, disconnecting the AC cord,
cold, dusty, or humid. grip the plug and not the
• Place the unit on a flat and cord itself. Pulling the cord
even surface. may damage it and create
• Do not restrict the air flow of hazard.
the unit by placing it in a • When you are not going to
place with poor air flow, by u s e t h e u n i t f o r a l o n g
covering it with a cloth, or by period of time, disconnect
placing it on a carpet. the AC power cord.
ON CONDENSATION
ON AC VOLTAGE
• Before use, check that the • When left in a heated room
rated voltage of your unit where it is warm and damp,
matches your local voltage. water
condensation may form
FCC INFORMATION (FOR USA
inside the CD player.
ONLY)
• When there is condensation
This device complies with Part
inside the unit, the unit may
15 of FCC Rules.
not function normally.
Operations are subject to the
• Let it stand for 1 to 2 hours
following two conditions:
before turning the power on,
(1) This device may not c a u s e
or gradually heat the room
harmful interference, and (2)
up and dry the unit before
T h i s d e v i c e m u s t a c c e p t
use.
a n y interference received,
Should any trouble occur,
including interference that may
disconnect the AC power
cause undesirable operations.
cord and refer servicing to
qualified personnel.
SYSTEM CONNECTIONS
SPEAKERS CONNECTING
• Connect the wires to the speaker terminals in correct posi-
tion.
• Connect speakers other than the speakers supplied with the
unit may damage the unit.
AC POWER CONNECTING
• Before use, check that the rated voltage of your unit
matches your l o c a l v o l t a g e . M a k e s u r e s p e a k e r s a r e
connected correctly before plugging the AC power cord
into an AC outlet.
CAUTION :
• Be sure the AC power cord is disconnected and all functions
are off before making connections.
2
• TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT (FOR USA AND CANADA
ONLY).
FM ANTENNA
• Do not connect to an outside antenna.
PARTS IDENTIFICATION
1. CD door
2. POWER STANDBY indicator
3. ON indicator
4. VOLUME control
5. FM STEREO indicator
6. FUNCTION switch (ST.BY/TAPE/TUNER/CD)
7. PHONES jack
8. CD OPEN/CLOSE button
9. CD REPEAT ALL DISC button
10. CD REPEAT ONE/DISC button
11. CD STOP button
12. Cassette holder
13. CD display
14. TUNING control
15. Remote sensor
16. Mode selector (BEAT CUT / FM MODE)
17. BAND selector (FM/AM)
18. DISC SKIP button
19. CD SKIP/SEARCH button
20. CD PLAY/PAUSE button
21. Cassette operation controls
REC button
PLAY button
REWIND button
F.FWD (fastforward) button
STOP / EJECT button
PAUSE button
connecting or
COMPACT DISC (CD) DISPLAY
droplets or
1. REPEAT mode indicator
2. DISC indicator
3. Playback indicator
TO ADJUST THE VOLUME
Adjust the VOLUME control to obtain the
desired volume level.
FOR PERSONAL LISTENING
Connect headphones (Ø3.5mm stereo mini
plug) to the PHONES jack.
Adjust the VOLUME for the desired listening level.
When headphones are connected, the speakers are auto-
matically disconnected.
WHEN RECORDING
The VOLUME controls switch on may be adjusted with no effect
on the recorded signal.
1. Set the FUNCTION switch to
TUNER.
3. Tune into a station.
1
FOR BETTER RECEPTION
F u l l y u n w i n d
a n t e n n a . T h e n e x t e n d t h e
wire antenna and place it in
the position that sound best.
NOTE:
DO NOT CONNECT
ANTENNA WIRE TO OUTSIDE
ANTENNA.
FM
TO RECEIVE THE FM BROADCAST IN STEREO
Set the Mode selector to FM.ST.
When the FM STEREO broadcast is received, FM STEREO indicator
lights up.
IF THE FM BROADCAST SIGNAL IS WEAK
Set the Mode selector to FM MONO position to turn off the FM
STEREO indicator and background noises become monaural.
AFTER LISTENING
Set the FUNCTION switch to ST.BY (Standby).
COMPACT DISC PLAYBACK
1. Set the FUNCTION switch
to CD.
3. Press the DISC SKIP button to revolve the tray clockwise.
Place other disc(s) on the disc holder(s).
WARNING: Take out all discs from the disc tray before
transportation.
GENERAL OPERATION
4. Pause indicator
5. Track indicator
SOUND ADJUSTMENT
RADIO OPERATION
2. Select the desired band.
4. Adjust the volume.
RADIO OPERATION
t h e w i r e Rotate the unit to get the
best receiving position.
FM
2. Press the OPEN/CLOSE button to
open the disc tray. Place the first
disc onto the disc holder, with
the label side up.
COMPACT DISC PLAYBACK
4. Press the OPEN/CLOSE button to close the disc tray. It takes a
short while for your player to check the discs.
5. Press the DISC SKIP button to select the desired disc. Press
either one of the SKIP/SEARCH buttons to select the desired
track.
6. Press PLAY/PAUSE button to start playback.
To stop playing:
a) For a moment only, press
be displayed. Press this button again to resume playing.
b) Press CD STOP button.
NOTE:
• To locate a track of currently selected disc, press
SKIP/SEARCH button repeatedly.
• To locate a track of another disc, press DISC SKIP button to
get to desired disc first and then press
SEARCH button repeatedly.
• To search a track, keep
and release it at desired point.
FORWARD
REVERSE
SKIP
PRESS IT REPEATEDLY
CD REPEAT PLAYBACK
REPEAT PLAYBACK - DURING PLAYBACK MODE
To repeat the current track
• Press REPEAT ONE/DISC button until REPEAT ONE appears
on the CD display and the currently playing track will be played
repeatedly until the stop button is pressed.
• Press or SKIP buttons with repeat function on, repeat
can still skip through different track of the currently selected
disc.
To repeat the whole disc
• Press REPEAT ONE/DISC button until REPEAT ONE DISC appears
on the CD display and the current disc will be played repeatedly
starting from the currently playing point.
• Press or SKIP buttons with REPEAT ONE/DISC function
AM / MW
on, one can still search through the whole disc, and the player
may start playing from the selected point.
To repeat all disc
• Press REPEAT ALL DISC button until REPEAT ALL DISC
appears on the CD display.
• Press on / SKIP buttons can make the player start playing
from the newly selected point of the currently playing disc.
• Press on DISC SKIP button can make the player start playing
from the first track of the newly selected disc. The
SKIP buttons can be used to choose a particular track on this
selected disc, the player will then start playing from that point.
To cancel repeat play
• Press either one of the REPEAT buttons until the word 'REPEAT'
disappears from the CD display.
ATTENTION - If the CD player does not operate
1. Slide the FUNCTION switch
from CD to ST.BY (Standby).
PLAY / PAUSE button and " " will
or
or SKIP/
or SKIP/SEARCH button pressed
REVERSE FORWARD
SKIP
SEARCH SEARCH
KEEP IT PRESSED
/
properly
2. Slide the FUNCTION switch
from ST.BY to CD.