Safety Instructions; General Information - Helios AIR1-AAHA Series Installation And Operating Instructions Manual

Installation and Operating Instructions
EN
CHAPTER 1
SAFETY
m
DANGER
m
WARNING
m
CAUTION
CHAPTER 2

GENERAL INFORMATION

Outside air intake hood – AIR1-AAHA / Exhaust air discharge hood – AIR1-AAHF
1.1 Important information
In order to ensure complete and effective operation and for your own safety, all of the following instructions should be
read carefully and observed.
This document should be regarded as part of the product and as such should be kept accessible and durable. The
operator is responsible for complying with all plant-related safety regulations.
1.2 Warning instructions
The adjacent symbols are safety-relevant prominent warning symbols. All
safety regulations and/or symbols in this document must be absolutely
adhered to, so that any risks of injury and dangerous situations are pre-
vented!

1.3 Safety instructions

Special regulations apply for use, connection and operation; consultation is
required in case of doubt. Further information can be found in the relevant
standards and legal texts.
m With regard to all work, the generally applicable safety at work and acci-
dent prevention regulations must be observed!
• Do not stand under suspended loads!
• The installation must only be carried out by suitable specialist personnel!
• Only transport fans using means of transport that are appropriate for the
weight. Wear protective footwear during transport!
• Wear protective gloves/footwear when unpacking the unit.
• Ensure the suitable load capacity and properties of the mounting surface
and use suitable mounting material.
• All plant-related safety regulations must be observed! If applicable, further
country-specific regulations must also be observed!
• The outlet area must be kept free from objects and material that could be
ejected.
• A uniform inflow and free outlet must be ensured!
1.4 Area of application
Intended use:
The outside air intake hood or exhaust air discharge hood is designed for installation on an AIR1 ventilation unit in
series XH or RH to prevent the freezing of dirt particles or the like. The outside air intake hood has a droplet separator
to prevent the ingress of water in the ventilation unit.
The outside air intake hood or exhaust air discharge hood is designed exclusively for AIR1 ventilation units in series XH
or RH from Helios Ventilatoren.
AIR1-AAHA
Outside air intake hood
1.5 Personnel qualification
The installation may only be carried out by specialists (e.g. industrial mechanics, mechatronics engineers, metal workers
or persons with comparable training).
2.1 Warranty claims – Exclusion of liability
All versions of this documentation must be observed, otherwise the warranty shall cease to apply. The same applies
to liability claims against Helios Ventilatoren. The use of accessory parts, which are not recommended or offered by
Helios, is not permitted. Any possible damages are not covered by the warranty. Changes and modifications to the
unit are not permitted and lead to a loss of conformity, and any warranty and liability shall be excluded in this case.
2.2 Shipping
The outside air intake hood or exhaust air discharge hood is packed ex works in such a way that it is protected against
normal transport strain. Carry out the shipping carefully. It is recommended to leave the unit in the original packaging.
AIR1-AAHF
Exhaust air discharge hood
1