Table of Contents
Advertisement
Troubleshooting
In the following cases
Picture not clear
Rolling
Overlapping
Spot or ripple
Although there are pictures,
no audio signal from the
loudspeaker.
There are pictures, but no
sound from the earphone. Earphone connected to
All pictures are dim.
Frequency indicator panel
keeps searching.
(continued)
Cause
Used up battery.
(Red indicator for battery
replacement is lit).
Telescope antenna not
adjusted correctly.
Channel not selected
properly.
Poor receiving environment.
Too strong waves
Reflected waves from the
receiving hill or building.
Min. volume.
Earphone, etc. connected to
the earphone terminal.
Too strong waves.
Min. volume.
other terminals than the
earphone terminal.
Used up batteries.
(Red indicator for battery
replacement is lit).
TV set body and batteries
are too cold.
Used up batteries.
(Red indicator for battery
replacement is lit).
Poor receiving environment. Move the set to a location with good
Solution
Replace with all new batteries
Adjust its length and direction.
Select channels by pressing the
selection buttons, and shorten
length of the telescope antenna.
Move it to a location with good
receiving environment.
Select channels by pressing the
selection buttons, and shorten
length of the telescope antenna.
Select channels by pressing the
selection buttons, and shorten
length of the telescope antenna.
Rotate volume button to adjust it to
a proper volume.
Pull out what is connected to the
earphone terminal.
Select channels by pressing the
selection buttons, and shorten
length of the telescope antenna.
Rotate volume button to adjust it to
a proper volume.
Connect it to the earphone correctly.
Replace all with new batteries of the
same variety.。
Press the switch after leaving the
set at locations with temperature
above 32ºF
Replace all with new batteries of the
same variety.。
receiving environment.
Advertisement
Table of Contents
