Advertisement
G: Internal Speaker (optional Navigation System required)
H: LCD Brightness Control
I: Internal Infra-RED Receiver for use with Navigation System Remote Control.
J: Power LED (Red when Power is on)
K: Display Timer Slide Control Switch: (optional Navigation System required)
Refer to # 3 below for detailed operation notes.
: " T/C " Button
L
The temperature/compass button switches between Fahrenheit and Celsius settings and
also turns the display on or off.
M: Internal Speaker Switch: Use to turn the internal Speaker on/off.
N: Calibration Switch: Used to calibrate the compass display.
II. Operation
The Mirror/monitor is automatically activated every time the Ignition key
is turned on. The mirror/monitor turns off every time the Ignition is
turned to the off position.
1. Rear Observation Camera (optional)
A. If a rear observation camera has been installed, the monitor will
automatically display the rear observation camera image whenever
the vehicle is shifted into reverse gear. The rear observation camera
image turns off automatically any time the gear selector is moved out
of the reverse position.
B. If you do not have an optional interior view camera installed,
pressing the "CAM" button at any time will display the image from
the rear observation camera onto the LCD for as long as the "CAM"
button is held.
2. Interior View Camera (optional)
If an interior view camera has been installed, pressing the "CAM" button
at any time will display the image from the interior view camera onto the
LCD for as long as the "CAM" button is held.
3. "TC" Button
The temperature/compass button switches between Fahrenheit and
Celsius settings and also turns the display on or off. Press once to turn on
the continuous temperature (F)/compass display. Press again to switch the
temperature display to Celsius. Next press will turn off the
temperature/Compass display
4. Navigation Image (optional Navigation System required)
The Navigation Image is the default mode, and will only be overridden
when the vehicle gear selector is moved into reverse, or if the CAM
button on the mirror is pressed.
Some operators may find that leaving the Navigation Image on the LCD
monitor at all times becomes a distraction while operating their motor
4
Advertisement
