Advertisement
Firmware upgrade
How do I upgrade my GoGear player with the latest firmware?
1.
Make sure that your computer is online and connecting to the Internet. Connect your GoGear player to the
computer.
2.
Launch the Firmware Manager at Start->Programs-> Philips Firmware Manager on your PC
3. A dialogue box will pop up; click Start to proceed with the upgrading of the firmware.
the player during the upgrading process as this interruption may damage the firmware!)
4.
Follow all screen instructions and click Finish at the end to complete the firmware upgrade.
5.
The Firmware Manager will close automatically. Close all opened application and then safely remove your
GoGearplayer by clicking on the EJECT HARDWARE icon in your task tray bar. When prompted, "The USB Mass
Storage Device can now be safely removed from the system", click OK and unplug your GoGear.
(Back to the top)
How do I recover my GoGear player to the factory setting?
1.
Make sure that your computer is online and connecting to the Internet. Launch the Firmware Manager at Start-
>Programs->Philips Firmware Manager on your PC.
2.
Connect your GoGear to the computer while pressing & holding the
the GoGear and a dialogue box pop up in recover mode.
3.
Click Start to confirm and start recovering the unit to its factory setting.
IMPORTANT: All music & content of your GoGear Player will be erased once the factory setting is
restored.
4.
Follow all screen instructions and click Finish at the end to complete the recovery.
5.
The Firmware manager will close automatically once the success message is displayed. Close all opened application
and then safely remove your GoGear by clicking on the EJECT HARDWARE icon in your task tray bar. When
prompted, "The USB Mass Storage Device can now be safely removed from the system", click OK and unplug your
GoGear.
(Back to the top)
(Please do not disconnect
key until the Firmware Manager recognize
Advertisement
