Cabling - FAB Media Encoder User Manual

C A B L I N G

Information

Cabling

Connect the cables according to the following drawing:
Following cables should be connected:
Video output of VTR to the
-
o VITC input of the timecode reader card.
o Video input of the video in a window card
o Use a BNC-T connector connected to the input of the timecode
reader card. This input has high impedance and is not terminated by
75 Ohm. If there is a DIP switch on the timecode reader set it to high
impedance.
Audio output of the VCR to the audio LINE IN input of the sound card.
-
LTC output of the VCR to the LTC input of the timecode reader card. The
-
LTC input consists of 2 RCA connectors. If the LTC signal is unbalanced
then use the upper RCA only. If the LTC signal is balanced then use both
RCA connectors.
By making the above connections all 3 cards should have their inputs connected.
The VITC/LTC connections are only necessary if VICT/LTC timecodes are
used.
You will see a view of the back of FAB Media Encoder on the following page.
LTC Out
Video Out
Audio Out
VTR
10
LTC In
VITC In
BNC-T
Timecode reader
Connector
Video In
Video in a w indow
Audio
Line In
Sound card
FAB Media Encoder
FT-MEDIAENC 1