Table of Contents
Advertisement
I N S T A L L I N G
Information
H A R D W A R E
&
S O F T W A R E
Information
Installation
Installation of FAB Media Encoder FT-MEDIAENC 1
This chapter will describe how to install the FAB Media Encoder system.
Generally the system comes with preinstalled hardware and software. In such
case you can skip the section with hardware and software installation and
continue with "Cabling".
Hardware and Software Installation
In case that the system has been delivered with hardware and software installed
proceed with the section "Cabling".
Hardware Requirements
The following hardware is required for FAB Media Encoder:
PC with 2.5 GHz Processor, 256 MB RAM, VGA Card
-
2 free PCI slots
-
Windows operating system
-
Hardware Installation
To install the hardware for FAB Media Encoder, open the PC and install the
following cards:
Video in a window card into a PCI slot
-
Timecode reader card into a PCI slot
-
In case that you will be using a CD-ROM or DVD-ROM writer also install
-
the writer and connect it
Close the cover of the PC and proceed with software installation.
8
2
Chapter
Advertisement
Table of Contents
