Silent Gliss 3000 Fitting Instructions

3000 Cord Drawn Curtain Track
WARNING Parents should realise that children could accidentally strangle in window blind
cords. Keep the cords out of the reach of children using one of these devices.
1. Clothes peg
or bulldog
clip
1
Firmly screw 3630 brackets to
wall or ceiling. The two outside
brackets should be located
12.5cm (5") in from the ends
of track to provide stability.
Remaining brackets should be
equally spaced along track
(approx. every 60cm/2').
3

EXTRA SUPPORT FOR CORD DROP

It is often desirable when the track is wall-fixed to make an extra fixing point over the end
where the cord is pulled to give greater rigidity. A special tubular spacer and 1
are supplied with all systems pre-packed by Silent Gliss.
4

TRIMMING AND/OR ADJUSTING INSTRUCTIONS

If it is necessary to shorten your 3000 curtain track follow all instructions (1-8 overleaf) for
pair stacking. For single stacking follow steps 1, 2, 4, 5, 6 & 7 only. To adjust the point where
the curtains meet, follow steps 3 and 8 only. If cord drop is required at opposite ends to that
supplied, simply follow step 3, pull cord through and the follow step 8.
Silent Gliss
Fitting Instructions
2. Cleat
Screw for wall or
ceiling with
universal bracket.
1. Unscrew
nylon cover.
P.T.O. These instructions are continued on reverse side.
®
3. Tie cord
to itself
2
To install track
simply locate as
shown and press
onto bracket in
direction
indicated.
2. Drill hole in wall
directly behind the 'X',
insert screw through hole
and spacer and screw
firmly into position.
Replace nylon cover.
4. Cord tidy
(Silent Gliss
part No. 3799)
Removal: Push upwards
and forwards.
/ " No. 8 screw
1
2
3000