Radio Frequency (Rf); Channelindicator; Automatic Horn Alert (Nam Option); Automatic - Audiovox CTX3200 User Manual

If the -1 indicator is on, the display will show
- - - - -
RADIOFREQUENCY

CHANNELINDICATOR

If necessary, you can see the RF channel number in
which your unit is operating.
q
1. Press m, key
The RF channel number, RSSI, SAT color code,
and transmitting power level will be displayed on
the readont. The display format is as follows:
RF channel number
RSSI value
SAT color code
Transmitting power level
2. When on a call, the display will update when a
handoff occurs.
3. The display will remain on the readout until you
manually reset it by pressing any key.

AUTOMATIC

HORN ALERT
(NAM OPTION)
This feature, when wired to the vehicle, indicates the
incoming call by sounding the horn or by flashing the
lights. When on, the Automatic Horn Alert will
automatically set each time that the car ignition is
turned off.
1. Press jFUNC1 then key
will appear on the display and the Automatic
Horn Alert mode will be on. Each time the igni-
tion is turned off, this feature will be set automati-
cally.
2. When a call is received, the unit will either sound
the horn or flash the lights five times, depending
on how the horn alert wire has been connected to
the car.
3. This mode will be off in the following cases
1) When WC] and then key m are pressed
again.
2) When the Calls in Absence Indicator mode is
set.
q
then
q
momentarily. I]
4. This feature is deactivated in the following cases:
position.
2) When the safety timer expires.
Deactivate this mode if it is not being used
Note(l):
as this feature remains activated even if
the power source is turned off.
Note(Z): The power source is automatically turned
off to prevent the discharge of the car
battery when the safety timer expires,
AUTOMATIC
CALLS IN ABSENCE
INDICATOR
This feature indicates the number of incoming calls
while you are out of the car. When the Automatic
Calls in Absence Indicator is on, it will be activated
when the ignition is turned off.
Press -1, then key
the display. However, this mode is not activated
unless the ignition switch is turned off.
2. Turn the ignition switch off and leave the tele-
phone switch on. If necessary, lock the unit.
When calls are received, the unit will indicate
them by flashing /CALL] and m (XX being the
number of calls) alternately in the display.
4. This mode will be off in the following cases
1) When -1 and then key
again.
2) When the Automatic Horn Alert is set.
3) When the Auto Answer Fax Data is set.
5. This feature is deactivated in the folowing cases:
1) By turning the ignition to on or accessory
position.
2) When the safety timer expires.
6. The [m and m will continue flashing until
any key is pressed or the handset is lifted.
Deactivate this mode if it is not being used
Note(i):
as this feature remains activated even if
the power source is turned off.
The power source is automatically turned
off to prevent the discharge of the car
battery when the safety timer expires.
q
will appear in
q
are pressed