Datatransmission; Manual Mode; Automatic Mode; Calltimedisplay - Audiovox CTX3200 User Manual

memory without annoying key tones over the circuit.
1. Press ml then key
number. (Tone/ will be displayed for 5 seconds.
The Microphone circuit will remain active, but
the tones will not be heard.
2. If necessary, press /STOI
address.
3. To exit the Scratch-pad Mode, press /FUNC/ ,then
key @ again or turn the unit off.

DATATRANSMISSION

AUX I/O JACK on the phone cradle can be used for
a FAX machine, Modem or other Data Transmitting
equipment. Specifications of AUX I/O JACK are as
follows.
JACK
600 ohms, Balance
Impedance
Input nominal - 17dBV
Level
Output nominal -32dBV

Manual Mode

To set Data Transmission Mode
After a call is in progress (answered or sent), press
t h e n m
readout. Then the transmission and receiving audio
will be switched to the AUX I/O JACK.
To Exit Data Transmission Mode
Press (FUNC/ then m
The indication JDatal on the readout will go out.

Automatic Mode

1.
Before leaving the car, press -1, then key
(more than 1 second). The display shows (A.D/TI
The unit will remain power-on even after the igni-
tion switch is turned off. If necessary, lock the unit.
2. When a call is received, the unit will automatically
make the connection, then the transmit and
receive audio will be switched to the AUX I/O
JACK.
3. This mode is automatically deactivated in the
following cases:
1) When the ignition switch is turned back to
"on" or "accessory" position.
2) When the safety timer is expired. (Refer to
"Safety Timer".)
3) When -1, then key
4) When Calls in Absence Indicator feature is
activated.
q
then enter a phone
then enter the memory
w i l l a p p e a r o n t h e
or terminate a call.
q
q
are pressed again.

CALLTIMEDISPLAY

This feature automatically records the elapsed time
per conversation. The talk time of the last call,
cumulative talk time, and the number of calls can be
displayed on the readout.
The timers can also be cleared if necessary.
With beep tones you can be notified of the approxi-
mate talk time (NAM Option) in approximately 60
second increments.

To Display the Talk Time of the Last Call

1.
Press m key @ then B
The talk time of the last call will be displayed on
the readout for 5 seconds.
While in a conversation, the talk time of a call in
progress will be displayed, and updated each sec-
ond. The display format is as follows.

To Display the Cumulative Talk Time

1.
Press m key @ then
The cumulative talk time will be displayed on the
readout in minute format for 5 seconds.
.

To Display the Number of Calls

1. Press m, key @j then
The number of calls will be displayed on the
readout for 5 seconds. The display format is as
follows.

To Clear the Timer

1.
Press (CLRI then enter the three-digit security
code.
q
2. Press ISTO/ key
The timers will be cleared, and the count for the
cumulative talk time and the number of calls will
start from zero.
One Minute Beep (NAM Option)
During conversation, you can be notified of the
approximate talk time by tones for the first five
minutes. (A short monotone signal will sound every
minute and a double beep tone will be heard after
approximately 5 minutes.)
q
q
then fl